Silicone Tubing1 mm to 40 mm ID, in 50 m coils or cut to length
We extrude silicone tubing for drinking water lines, for sleeving wires and for use as gaskets. Compliant grades for food, pharmaceutical and potable water service go out with their documents on every dispatch.
Sizes, cure and compliance
We make compliant grades for the standards listed below. Tell us which your application needs.
- Bore
- 1 mm to 40 mm ID
- Wall
- From 0.5 mm
- Cure
- Peroxide or platinum
- Colours
- Clear, translucent or coloured
- Supplied as
- Coils, usually 50 m, or cut to length
- Compliant grades
- FDA 21 CFR 177.2600, BfR Recommendation XV, USP <87>/<88> (Class VI), BS 6920
- Documents
- With every dispatch
- Other materials
- EPDM tubing to order
Where our tubing goes
Some of these uses are what you would expect. One of them surprises people.
Tubing for drinking water transfer, in compliant grades.
Very thin-wall tubing slid over wires as a sleeve.
Tube used as a gasket in its own right.
Cut to length and joined, a silicone tube becomes a hollow O-ring: a compressible seal made from standard tube. See joined gaskets.
Buy it by the metre, not the kilogram
A lot of tubing is quoted per kilogram, and buyers like it because it looks easy to compare. The moment filler goes into rubber, its density goes up and the metres you get from each kilogram go down. Buyers who compare per kilogram get caught out in the long run.
We usually quote tubing by the metre, so you know what a metre costs before you order. Our Purity Promise explains the arithmetic.
Silicone tubing
From 1 mm to 40 mm ID, with walls from 0.5 mm.
Send us the bore, the wall and the use
Send the ID, wall thickness, length and what the tubing will carry. We will suggest the grade and quote by the metre.