Silicone & Rubber ProfilesExtruded in silicone and EPDM
Not every extrusion is a gasket. People buy our profiles for edge protection, for damping and for noise insulation.
Dies, sizes and colours
We have over 500 dies on hand. If yours is not one of them, a new die takes 2 to 3 days and starts from ₹3,000.
- Dies on hand
- Over 500
- New dies
- 2 to 3 days, from ₹3,000
- Materials
- Silicone and EPDM
- Hardness
- Silicone from 30 Shore A, EPDM from 40, up to 85 Shore A
- Size
- 0.8 mm to 75 mm wide, walls from 0.3 mm
- Tolerance
- ±0.15 mm on critical dimensions, ±0.3 mm on the rest
- Silicone colours
- Clear, red, white, grey, black, or matched to a RAL number
- EPDM colours
- Off-white and black
Profiles for LED strips
We make silicone profiles for LED strips to your design, in clear or translucent. They need a specific grade of silicone, so there is a minimum order quantity before they make sense to run.
What we do not do
We do not co-extrude. A single profile cannot combine two hardnesses, or a sponge section on a solid base.
If the profile is there to seal, see extruded gaskets and sponge gaskets.
Rubber profiles
Over 500. A new die takes 2 to 3 days and starts from ₹3,000.
Send us the section
Send a drawing or a sample of the profile, the colour and the quantity. We will check our dies first.